toolskoInstant Results. Privacy First.

Roof Snow Load Calculator: How Much Does Snow Weigh?

How heavy is the snow on your roof? Estimate pounds per square foot for fresh, wet or packed snow and ice, and compare it with your roof’s snow load.

Tool inputs stay in your browser · optional AI search sends your query

Good to know: Scope: a rough estimate of the weight of snow and ice sitting on a house or small building roof, using published weights: FEMA’s Snow Load Safety Guide (P-957) says 1 foot of fresh snow weighs about 3 pounds per square foot (psf) when light and dry and about 21 psf when wet and heavy, 1 inch of ice a little under 5 psf and 1 foot of ice about 57 psf; the Maine Emergency Management Agency says 10 to 12 inches of new snow, or 3 to 5 inches of old (packed) snow, equals about 1 inch of water, or about 5 psf. Because real snow density varies, the tool shows a low-to-high range. It compares the result with your roof’s design snow load if you know it, or else with the 20 psf rule of thumb that Maine EMA quotes from the Insurance Institute for Business & Home Safety (IBHS); older roofs may hold less. Not included: drifts, sliding snow and uneven piles (FEMA says to clear drifts first), rain on snow, ground snow loads or building-code design (ASCE 7 / IBC), flat commercial roofs, decks, carports and tents, and anything about your specific building — this is not an engineering check. Nothing you type is sent or saved. Sources reviewed November 17, 2026.

How to use it (step by step)

  1. 1Estimate how deep the snow is on the roof itself (not the ground: FEMA notes 1 foot on the ground is not always 1 foot on the roof). Enter fresh snow and pick light, typical or wet; add any older packed snow and ice underneath.
  2. 2Optional: enter the roof area in square feet for the total weight, and your roof’s design snow load in psf if it is on your house plans. Leave it blank to compare with the 20 psf rule of thumb.
  3. 3Read the estimated load and how it compares with your roof. If it is close to or over the limit, or you see warning signs, have snow removed from the ground or by a licensed, insured professional.

Words to know

Pounds per square foot (psf)
How much weight presses on each 1 foot by 1 foot square of the roof. Multiply by the roof area to get the total weight.
Design snow load
The snow weight the roof was built to carry, chosen by the designer from building codes. It is usually on the construction drawings.
Old or packed snow
Snow that has settled, been rained on or partly melted. It is much denser, so a few inches can weigh as much as a foot of fresh snow.
Roof rake
A long-handled tool for pulling snow off a roof while you stand on the ground. FEMA recommends non-metal rakes; metal ones can damage the roof and conduct electricity.

Explore tools for Australia, the US & Europe →

Sources & methods

References checked November 11, 2026. Read each tool’s scope and assumptions before relying on its result.

Spotted a wrong result or an outdated rule? Report a mistake · How we check our tools · Get new tools by email

Related tools

See all tools in the Home Improvement & Construction Calculators →